RAID® WASP & HORNET KILLER 33

Kills the entire nest.
Raid Wasp Raid® Wasp & Hornet Killer 33

RAID® WASP & HORNET KILLER 33

Raid® Wasp & Hornet Killer allows you to spray up to 22 feet, killing the entire nest. 

• It kills wasps and hornets on contact and is electrically non-conducting up to 32,500 volts.

Highlights below. Full label available here >>
  • For outdoor use only.
  • Spray in early morning or early evening when insect activity is minimal.
  • Stand a safe distance from the nest and not directly underneath.
  • Hold the can as upright as possible.
  • Point spray opening toward the nest with the wind at your back.
  • Spray until nest is thoroughly saturated to kill the entire nest population.
  • Exit area immediately and remain outside the treated area until all sprays have dried.
  • Wait at least 24 hours before removing the nest.
Tips & Tricks
tips and tricks

Inspect screens for holes and loose edges that may allow wasps and hornets to enter.

-

Keep a tight fitting lid on garbage cans to avoid attracting wasps.

Prallethrin (0.02%)

Cypermethrin (0.05%)

Other Ingredients (99.93%)

Also contains petroleum distillates

For more detailed information on ingredients, see: 
https://www.whatsinsidescjohnson.com/us/en/brands/raid/raid-wasp-and-hornet-killer-33
• Exit area immediately and remain outside the treated area until all sprays have dried.

• Wash thoroughly with soap and water after handling.

• If on skin or clothing: Take off contaminated clothing. Rinse skin immediately for 15-20 minutes.

• If swallowed: Immediately call a poison control center or doctor. Do not induce vomiting unless told to do so by a poison control center or doctor. Do not give anything by mouth to an unconscious person.

• Environmental Hazards: This product is extremely toxic to fish and aquatic invertebrates. Do not apply directly to or near water.
• If empty: Place in trash or recycle if available.

• If partially filled: Call your local solid waste agency or call 1-800-529-3394 for disposal instructions. Do not allow the product to enter any drain during or after application.